Mount your Cycling Computer and Camera Out front and Center using just One mounting arm. Slide and Rotate the Computer to the Optimum Viewing Angle and position your camera below the bars and out of harms way.
Works with GARMIN® EDGE 200, 500, 800, 1000, Touring series computers and all GoPro® Hero Cameras and Action Cameras
Mounting Arm
- Mount up to Two devices on one Mounting Arm
- Mount your devices out-front or behind the bars
- Rotate and slide your devices to multiple positions
- Free up bar space with only one mount for all your devices
- Buy only one mount and save money
- No need to buy new mounts for new devices
- Strong, light, and shock absorbing
- Fits all 31.8mm diameter bars
- Torque not to exceed 1.6Nm/14inlbs
Cycling Computer Adapter
- Works with GARMIN® EDGE 200, 500, 800, 1000, Touring series computers.
- Slide and Rotate: Slide and Rotate your computer to most positions.
- Eliminate Glare: Rotate your computer to Eliminate Glare.
- Optimize the Viewing Angle: Rotate and Slide the computer to your Optimum-Viewing Angle.
- Torque not to exceed 1.6Nm/14inlbs
- Camera Adapter works with all GoPro® Hero Cameras and Action Cameras
- Positions your Camera Out front and Center
- Camera can be mounted facing forward or backwards
- Rotate and Slide your Camera to capture different views
- Mounts Upside down or Right side up
- Easily remove and attach the camera with the quick release adapter
- Torque not to exceed 1.6Nm/14inlbs.
Weight 54g
Designed, Engineered and Made in the U.S.A
Instructions
Mounting Arm
- Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
- Torque not to exceed 1.6Nm/14inlbs.
Adapters
- Remove the bolt and washer from the adapter and install into the mounting arm slot.
- Thread on the adapter with the washer on the opposite side flush against the bolt head.
- Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
- Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.
Carbon Fiber Stem Mount
- Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
- Don’t use excessive force it may break the product and void the warranty.
- Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
- Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
- Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.